[3DMakerworld] Adafruit NeoPixel Digital RGB LED Strip - Black 30 LED - 1 meter

Description

Key Features:
Control each LED individually by setting the color of each LED's red, green and blue component
30 RGB LEDs per meter
Easy to cut, black, flexible PCB Material marked with cut-lines
Connect more LEDs to make strip longer
These NeoPixel strips have 30 digitally-addressable pixel LEDs per meter and are very affordable and are only 12.5 mm wide, 10 mm if you remove the strip from the casing. The strip is made of black flexible PCB material, and comes with a weatherproof sheathing with 1.3" cut lines to shorten the strip. You can also connect strips together to make them longer, just watch how much current you need! A 5V/2A supply should be able to drive 1 meter and a 5V/10A supply can drive up to 10 meters. You must use a 5V DC power supply to power these strips, do not use higher than 6V or you can destroy the entire strip. The LEDs are controlled by shift-registers that are chained up down the strip so you can shorten or lengthen to your desire. Only 1 digital output pin are required to send data down. The 8-bit precision PWM is built into each LED-chip so once you set the color you can stop talking to the strip and it will continue to PWM all the LEDs for you.
Item Specifics
Casing Color: Black
Width: 12.5mm (0.5") wide
Thickness: 4mm (0.16") thick w/ casing, 1.85mm (0.07") thick w/o casing
Segment Length: 33mm (1.3") long
Strip Length: 1 meter (30 LEDs)
Removable IP65 weatherproof casing
Maximum 5V @ 60mA draw per 1.3" strip segment (all LEDs on full brightness)
5VDC power requirement (do not exceed 6VDC) - no polarity protection
1 integrated RGB LEDs per segment, individually controllable
LED wavelengths: 630nm/530nm/475nm
Connector: 2-pin JST SM
Strips may use either WS2812B or SK6812-based LEDs. They are the same brightness, color and protocol